CentOS / Redhat : Configure CentOS as a Software Router with two interfaces

CentOS / Redhat : Configure CentOS as a Software Router with two interfaces

 

Linux can be easily configured to share an internet connection using iptables. All you need to have is, two network interface cards as follows:

a) Your internal (LAN) network connected via eth0 with static ip address 192.168.0.1

b) Your external WAN) network is connected via eth1 with static ip address 10.10.10.1  ( public IP provided by ISP )

Please note that interface eth1 may have public IP address or IP assigned by ISP. eth1 may be connected to a dedicated DSL / ADSL / WAN / Cable router:

Step # 1: Enable Packet Forwarding

Login as the root user. Open /etc/sysctl.conf file

# vi /etc/sysctl.conf

 

Add the following line to enable packet forwarding for IPv4:

net.ipv4.conf.default.forwarding=1

 

Save and close the file. Restart networking:

# service network restart

 

Step # 2: Enable IP masquerading

 

In Linux networking, Network Address Translation (NAT) or Network Masquerading (IP Masquerading) is a technique of transceiving network traffic through a router that involves re-writing the source and/or destination IP addresses and usually also the TCP/UDP port numbers of IP packets as they pass through. In short, IP masquerading is used to share the internet connection.

 

Share internet connection

To share network connection via eth1, enter the following rule at command prompt (following useful for ppp0 or dial up connection):

 

# service iptables stop

# iptables -t nat -A POSTROUTING -o eth1 -j MASQUERADE

# service iptables save

# service iptables restart

 

Make sure Iptables runs on boot

 

# chkconfig iptables on

 

 

Open your Windows / Mac / Linux computer networking GUI tool and point router IP to 192.168.0.1 (eth0 Linux IP). You also need to setup DNS IP such as 8.8.8.8 or to your local DNS server IP. You should now able to ping or browse the internet:

 

# ping google.com

Client Side Configuration

Now all you have to do is set the IP 192.168.0.1 as gateway on all your client machines in your network. You can enter  your default gateway in the file /etc/sysconfig/network as:- 
GATEWAY=192.168.0.1
or you can also put the same entry in your interface specific file at /etc/sysconfig/network-scripts/ifcfg-eth0 in case of RHEL/Centos or at /etc/network/interfaces in case of ubuntu.

- See more at: http://www.linuxtechtips.com/2013/12/configure-centos-as-a-router.html#.dpuf