装完RHEL7后,重新开机启动后显示: 1) [x] Creat user 2) [!] License information (no user will be created) (license not accepted) Please make your choice from above ['q' to quit | 'c' to continue | 'r' to refresh]: 解决方法: 输入"1",按Enter键 输入"2",按Enter键 输入
转:装完Centos7提示Initial setup of CentOS Linux 7 (core) 在用U盘装完CentOS后,重新开机启动后显示: Initial setup of CentOS Linux 7 (core) 1) [x] Creat user 2) [!] License information (no user will be created) (license not accepted) Please make your choice from above ['q
问题: CentOS7安装完毕,重新开机启动后显示: Initial setup of CentOS Linux 7 (core) 1) [x] Creat user 2) [!] License information (no user will be created) (license not accepted) Please make your choice from above ['q' to quit | 'c' to continue | 'r' to refresh]: 解决方法:
CentOS7安装完毕,重新开机启动后显示: Initial setup of CentOS Linux 7 (core) 1) [x] Creat user 2) [!] License information (no user will be created) (license not accepted) Please make your choice from above ['q' to quit | 'c' to continue | 'r' to refresh]: 解决方法: 输入“
通过csv data set config 设置参数化后,执行结果显示为<EOF>: 反复确认相应的参数的设置均没有问题,其中csv文件编码方式采用uft-8.在csv data set config 中编码方式也采用uft-8. 为什么会出现执行结果显示为<EOF>??我想会不会是编码的问题.于是把csv data set config 中编码方式调整为gb2312.把csv文件编码方式调整为ANSI. 在请求中可以查看到,对应的请求为正确的数据.